Hitachi XP P9500 User Manual page 360

Specify the current AutoPATH_ID of the target path, which is displayed by
using the view operation. For details about the view operation, see
(Displays Information) on page
(000001 and 1 indicate the same AutoPATH_ID); however, when the
target AutoPATH_ID is 000000, enter 000000 or 0 for the parameter
value.
AutoPATH_IDs are re-assigned every time the host is restarted. When you
want to add a new LU without restarting the host, AutoPATH_IDs are re-
assigned to each path of the LU when you execute the dlmcfgmgr utility
for managing the HDLM configuration. Always make sure that you use the
view operation to find the current AutoPATH_ID of the target path, before
executing the offline operation.
-device SCSI-device-name
Use this parameter to place offline a path connected to the specified SCSI
device.
For SCSI-device-name, specify the value of Device displayed by
executing the view operation as follows:
# /opt/DynamicLinkManager/bin/dlnkmgr view -lu
For details on how to execute the view operation and display the SCSI
device name, see
(To display program information) on page
parameter value can be specified.
Example
-s
Executes the command without displaying the message asking for
confirmation of command execution from the user. Specify this parameter
if you want to skip the response to the confirmation message: for
example, when you want to execute the command in a shell script or
batch file.
Example
6-8
To display LU information on page 6-47
The following shows an example of how to place offline a path whose
SCSI device name is /dev/sde while confirming command operation.
# /opt/DynamicLinkManager/bin/dlnkmgr offline -path –device /
dev/sde
KAPL01052-I The currently selected paths will be changed to
the Offline(C) status. Is this OK? [y/n]:y
KAPL01053-I If you are sure that there would be no problem
when the path is placed in the Offline(C) status, enter y.
Otherwise, enter n. [y/n]:y
KAPL01061-I 1 path(s) were successfully placed Offline(C); 0
path(s) were not. Operation name = offline
The following example shows how to place a path, whose
AutoPATH_ID is 000001, offline without asking for confirmation of
command execution from the user:
# /opt/DynamicLinkManager/bin/dlnkmgr offline -pathid 1 -s
Command Reference
Hitachi Dynamic Link Manager User Guide (for Linux(R))
6-28. Leading zeros can be omitted
6-29. Only one case-sensitive
view
in Parameters