Table of Contents
Advertisement
Video Termination Switches (When using the looping connector)
The termination switches are located near the rear panel on the main circuit board. The 75 ohm termination is
enabled when the switch is in the "ON" position. The factory setting of 75 ohm termination for each camera input is
ON. If cameras are to be looped out to other devices, set the termination switch to off.
Setting method
(1) Disconnect the AC adapter. Remove the 8 screws from the side and the 2 screws from rear, then take off the top
cover.
(2) Set the switches (SJ01, SJ02) on the main circuit board to ON or OFF.
(3) Attach the top cover and tighten the screws in their original positions.
(4) Attach the AC adapter.
ON
1
2
3
4
SJ01
ON
1
2
3
4
SJ02
5
6
7
8
5
6
7
8
No.
Input Name
1
Camera 1
2
Camera 2
3
Camera 3
4
Camera 4
5
Camera 5
6
Camera 6
7
Camera 7
8
Camera 8
No.
Input Name
1
Camera 9
2
Camera 10
3
Camera 11
4
Camera 12
5
Camera 13
6
Camera 14
7
Camera 15
8
Camera 16
- 12 -
Advertisement
Table of Contents
