Cpc Signal Detection Incoming Set - Panasonic KX-TD308 Installation Manual

4.6 Outside Line Programming

CPC Signal Detection Incoming Set

Description
Selection
Default
Programming
Conditions
Feature References
Assigns the expected minimum duration of the Calling Party
Control (CPC) Signal on incoming outside calls. If this is
programmed, the system disconnects the line when the CPC Signal
is detected.
• Outside line (CO) number: 1 through 3,
• Time (milliseconds): Disable (no detection) / 100 / 200 / 300 /
All outside lines – 400 ms
1. Enter 405.
Display: 405 CPC INCOMING
2. Press NEXT.
Display: CO Line NO?
3. Enter an outside line number.
To enter outside line number 1, you can also press NEXT.
Display example: CO1:400msec
4. Keep pressing SELECT until the desired time is displayed.
5. Press STORE.
6. To program another outside line, press NEXT or PREV, or
SELECT and the desired outside line number.
7. Repeat steps 4 through 6.
8. Press END.
• To assign all outside lines to one selection, press the
In this case, the display shows the contents programmed for outside line
1.
• You may disable CPC Signal Detection for an outside line.
• Program [415] "CPC Signal Detection Outgoing Set" is used to
program CPC Signal Detection for outgoing outside calls.
Section 3, Features
Calling Party Control (CPC) Signal Detection
Direct Inward System Access (DISA)
400 / 500 / 600
System Programming
405
( =all outside lines)
key in step 3.
4-99