Cpc Signal Detection Incoming Set - Panasonic KX-TD308 Installation Manual

Outside Line Programming
4 6
l

CPC Signal Detection Incoming Set

Description
Selection
Default
Programming
Conditions
Feature References
Assigns the expected minimum duration of the CPC Signal on
incoming outside calls. If this is programmed, the system
disconnects the line when the CPC Signal is detected.
Outside line (CO) number: 1 through 3, * ( * =all outside lines)
l
Time (milliseconds): Disable (no detection) / 100 / 200 / 300 /
l
All outside lines - 400 ms
1. Enter 405.
Display: 405 CPC INCOMING
2. Press NEXT.
Display: CO Line NO?+
3. Enter an outside line number.
To enter outside line number 1, you can also press
Display example: C01:400msec
4. Keep pressing SELECT until the desired time is displayed.
Press STORE.
To program another outside line, press NEXT or PREV, or
SELECT and the desired outside line number.
Repeat steps 4 through 6.
Press END.
To assign all outside lines to one selection, press the Jt key in step 3.
l
In this case, the display shows the contents prograquned for outside line
1.
You may disable CPC Signal Detection for an outside line.
l
Program [415] "CPC Signal Detection Outgoing Set" is used to
l
program CPC Signal Detection for outgoing outside calls.
Section 3, Features
Calling Party Control (CPC) Signal Detection
Direct Inward System Access (DISA)
NEXT.
System Programming 4-99