Panasonic KX-TD308 Installation Manual page 282

System Programming
4 3
l
Selection
Default
Programming
Conditions
Feature References
VM Command DTMF Set
LV-MSG / GETMSG / AA-SVC / VM-SVC
l
DTMF signal number:
l
LV-MSG - H; GETMSG - X H; AA-SVC - #8 ; VM-SVC - #6
1. Enter 114.
Display: 114 VM DTMF CMD
2. Press NEXT to program the LV-MSG command.
To program another command, keep pressing
command is displayed.
Display example: LV-MSG:H
3. Enter a DTMF signal number.
To delete the current entry, press
To change the current entry, press
4. Press STORE.
To program another selection, keep pressing NEXT or PREV
5.
until the desired selection is displayed.
6.
Repeat steps 3 through 5.
7. Press END.
A command signal number can have a maximum of 16 digits,
l
consisting of 0 through 9, * , ##, FLASH and PAUSE.
The FLASH button is available only for LV-MSG and GETMSG
l
commands to store "II" which means "Home Position".
If "II" is stored for "LV-MSG", a mailbox number programmed in
l
program [609] "Voice Mail Access Codes" or an extension number will
be sent to the VM port (Follow On ID function). If certain codes are
required before and after the ID code, insert "II" between the codes, as
If " * II" is stored for "GETMSG", a mailbox number programmed in
l
program [609] "Voice Mail Access Codes" or an extension number will
be sent to the port succeeding the "X ".
Section 3, Features
Voice Mail Integration
16 digits (max.)
NEXT
CLEAR.
CLEAR and enter the new number.
System Programming
1 1 4
until the desired
4-47