Caller Id Code Set - Panasonic KX-TD308 Installation Manual

Description
Selection
Default
Programming
Conditions
Feature References
System Programming
4 3 System Programming
l

Caller ID Code Set

Sets the identification code of the calling party (Caller ID Code) to
utilize Caller ID Service provided by a specific central office (CO).
If an ID Code transmitted from CO is found in the Caller ID Code
Table, the caller's ID Code or a name given to the code in program
[ 11 l] "Caller ID Name Set" is displayed on the telephone, allowing
the called party to recognize the caller.
001 through 100
Location number:
l
ID 11 digits (max.)
Caller Code:
l
All locations - Not stored
1. 110.
Enter
Display: 110 CALLER ID #
Press NEXT.
Display: Location NO?+
location number.
Enter a
To enter location number 001, you can also press NEXT.
Display example: OO1:Not Stored
Enter a
To delete the current entry, press CLEAR.
To change the current entry, press CLEAR and enter the new code.
Press STORE.
5.
To program another location, press
SELECT the
and
Repeat steps 4 through 6.
Press END.
Each Caller ID Code has a maximum of 11 digits, consisting of 0
l
through 9.
Program [ 11 l] "Caller ID Name Set" is used to give names to Caller ID
l
Codes. If an ID Code is given a name, the called party's telephone
shows the name in place of the ID Code.
Program [406] "Caller ID Assignment" is used to enable Caller ID
l
Service on an outside line basis.
Features
Section 3,
Caller ID
NEXT
location number.
desired
PREV,
or or