Setting Audio Level; Setting A Constant Audio Level For The Entire Event During Event Recording - Panasonic AJ-HPM200 Operating Instructions Manual

Memory card portable recorder/player
Hide thumbs Also See for AJ-HPM200:
Table of Contents

Advertisement

A fixed or variable audio level can be set for a specified section of the playlist. Review or playlist playback occurs at the set
audio level while Edit Copy generates material at the set audio level.
The audio level can be bet set when registering an event or for a specific audio section of already existing playlist.
◆ NOTE:
• The level setting is stored in memory, which limits capacity (time).
Estimate: About 10 minutes per channel
(Depends on level changes)
Any settings that exceed the limit disable the setting.
Setting a Constant Audio Level for
the Entire Event during Event
Recording
When registering a new event in a playlist, set a constant
audio level for the registered audio event.
5
STOP
REC
PLAYER
STILL/
SOURCE SELECT
PLAY
PAUSE
REW
COUNTER
RESET
REVIEW
PREV
1 CLIP PLAY
NEW
TC PRESET
PROP
T
TCG
REGEN
RESET
EXT
TO
UB
DE
UT
CLIP
SHIFT
F3
PF4
1
Assign IN and OUT points to enable event
registration.
➝Refer to "Registering Events in a Playlist" (page 89).
2
Use the UNITY/VAR channel selection switch on the
audio fader to select tracks for level setting.
3
Set the audio fader to the desired level.

Setting Audio Level

4
2
PREVIEW
A.LEVEL REC
CONTROL
MODE
REMOTE
LOCAL
FF
3
4
1 3
2 4
1
2
NEXT
UNITY
UNITY
10
0
10
20
30
CH
CH
1/3
2/4
PB
3
4
Use the REC button or PREVIEW button to register
the event.
This operation registers the event and an icon
indicating that a constant audio level setting has been
made appears on the event on the timeline.
5
Check audio level by performing a review or playlist
playback.
Check events for which a level has been set by pressing the
PLAY button or REVIEW (SHIFT + PLAY) button.
◆ NOTE:
• The audio level is not set if no new event has been registered in the
channel selected in step 2.
• If the level value is a UNITY value, the icon indicating a level setting
does not appear.
• To move the audio fader during a preview, refer to "Changing Audio
Level in an Event during Event Registration" (page 106).
• This method for setting the audio level is not available for a hard disk
or an external device used as a player.
Editing: Setting Audio Level
105

Advertisement

Table of Contents
loading

This manual is also suitable for:

Aj-hpm200pAj-hpm200e

Table of Contents