Table of Contents
Advertisement
Item
FR
SUPER
FR
No.
DISP.
No.
0000
0001
0002
148
WFM POS.
0003
0000
0001
0002
0003
155
AUTO REC
0000
0001
160
REPEAT PLAY
0000
0001
170
AVCHD REC
Setting
SUPER
DISP.
RT
Selects the position for the waveform monitor.
0: Top right
LT
1: Top left
RB
2: Bottom right
LB
3: Bottom left
OFF
Select whether recording and stopping should be performed automatically according to
the recording/stopping signals in the HD SDI input signals from Panasonic camera-
TYPE1
recorders.
TYPE2
0: No automatic recording/stopping
TYPE3
1: Recording and stopping is performed automatically according to the recording/
stopping signals in the LTC information attached to HD SDI signals.
2: Recording and stopping is performed automatically according to the recording/
stopping signals in the SVITC information attached to HD SDI signals.
3: Set when other manufacturer's camera-recorders are used.
NOTE:
• Set the CONTROL switch to REMOTE. Refer to "Panasonic camera-recorders,
recording formats and recording/stopping signals (Recording Mark)" on the next
page before selecting TYPE1 or TYPE2.
• Select TYPE1 or TYPE2. To start automatic recording, simultaneously press the REC
button and the STILL button to place this unit in the REC PAUSE mode. This function
will not work in any mode other than REC PAUSE. The unit returns to REC PAUSE
mode when automatic stop is activated.
• In normal recording mode, this setting is not available and auto stop is not activated.
• For the devices verified as TYPE3 devices, visit the following Web site:
For English: http://panasonic.biz/sav/autorec_e
OFF
Determines whether or not to engage repeat play during playback.
0: Does not engage repeat play. Stops playback at the end of the last clip.
ON
1: Engages repeat play. Continues playback from the beginning when reaching the end
of the last clip.
NOTE:
• Repeat play is not available when the PLAYLIST button is on and during TEXT MEMO
playback.
• If the P2 card is removed during repeat play, playback is suspended when playback
reaches the clip that is no longer exists.
• Even if you insert a P2 card during repeat play, additional clips are not played back
until you once stop repeat play and resume it.
OFF
59.94Hz
ON
Selects whether to make AVCHD recording to an SD card either in AVCHD mode or
simultaneous with recording to a P2 card.
0: No AVCHD recording
1: Makes an AVCHD recording to an SD card either in AVCHD mode or simultaneous with
recording to a P2 card.
NOTE:
• Displayed only when an AJ-YCX250G AVCHD codec board (optional) is installed.
• AVCHD recording is not available when 480i or 576i is set in setup menu No. 020 (SYS
FORMAT). Select up-conversion recording to record 480i and 576i input as AVCHD.
• Use the setup menu No.774 (AVCHD A CH) to select channels to record.
• The start and end of recording may not match the clip recorded on the P2 card.
• AVCHD recording is not available when setup menu No. 041 (LOOP REC) is set to
ON.
Settings and brief function description
only
50Hz
167
Setup: Item Settings
Advertisement
Table of Contents
