External Remote Control; Remote Operation Of External Devices - Panasonic AJ-HPM200 Operating Instructions Manual

Remote Operation of External Devices

Use the RS-422A or IEEE1394 interface to send commands to
an external device to control it.
The following functions permit remote control.
• PLAY, STOP, STILL, FF, REW, SHTL, JOG
• Counter and status LED indication
Setup Procedure
1
Press the PLAYER or SOURCE SELECT (SHIFT +
PLAYER) buttons.
• In the RS-422A interface, press the PLAYER button.
• In the IEEE1394 interface, press the SOURCE SELECT
(SHIFT + PLAYER) buttons.
OFF
METER
FULL/FINE
MONITOR
SELECT
METER SELECT
CH 1-4 CH 5-8
INPUT SELECT
VIDEO AUDIO
CH 1 CH 2
REC
VAR
UNITY
THUMBNAIL PLAYLIST
SET
MULTI
SEL
EXIT MENU
CANCEL/PF DIAG
OPERATION
• This allows the unit to perform remote control of external
devices.
◆ NOTE:
• Select 59.94, 50, 23.98, 24, 29.97 or 25 in setup menu No. 25
(SYSTEM FREQ) when using RS-422A.
• Select 59.94 or 50 in setup menu No. 25 (SYSTEM FREQ) when
using IEEE1394.
• In AVC-Intra50 and AVC-Intra100 formats, IEEE1394 input and
output are not available.
• Complete any settings required for controlling a remotely connected
device before switching.
124
Connections: External Remote Control

External Remote Control

1
REC
STOP
PLAYER
STILL/
SOURCE SELECT
PLAY PAUSE REW
COUNTER
RESET
REVIEW PREV
1 CLIP PLAY
NEW
TC PRESET
PROP
CH 3 CH 4
TEXT INT
TCG
MEMO
REGEN
PRESET
EXT
MARKER
VIDEO A1 A2 GO TO
EDIT MODE A3 A4 A.DUB
MODE
TRIM
LAST X
DELETE SLOT SELECT
ENTRY OUT
IN
SLOT CLIP
CLIP LIST ALL CLIP
SHIFT
PF1 PF2 PF3
PF4
1
Indications during control of external
devices
In external control mode, the PLAYER lamp goes on and the
unit provides the following indications.
• The LED goes on to indicate external device status.
• Indicates the external device counter
• The unit is forcibly set to EE to enable reception of audio
and video from the external device
• Counter, status and P mark indications for the external
device are superimposed on the screen.
◆ NOTE:
When 1394 input is selected and the unit is in STILL mode, it goes into
EE mode after engaging STOP mode.
PREVIEW
A.LEVEL REC
Remote operation procedure
FF
The control buttons listed below enable remote control of an
NEXT
external device.
STOP
PLAY
STILL
REW
FF
Dial
*1
COUNTER
*1
RESET
*1:Available only when using RS-422A
Sends the STOP command.
Sends the PLAY command.
Sends the STILL +0.0 command
Sends the REW command.
Sends the FF command.
Sends the SHTL or JOG command.
Sends the switch COUNTER command
(CTL/TC only).
Sends the 0 reset command in CTL mode.