Table of Contents
Advertisement
Up and down
Moves up or down tracks in events
cursor buttons
at the current playback position.
(▲ / ▼):
Hold down the SHIFT button and
press the ▲ or ▼ button to move to
the current playback location of the
video track or the lowest audio
track.
• During player thumbnail operation
These buttons move the cursor in the same way as the
thumbnail screen.
➝Refer to "Cursor operations in thumbnail screen"
(page 49).
• During menu operations
These buttons operate in the same way as in the
thumbnail menu.
➝Refer to "Moving Between Screens and Menu
Operations" (page 33).
5.
EXIT/CANCEL button
EXIT button
This button performs the same function as EXIT in a
menu.
CANCEL (SHIFT + EXIT) button
To cancel all selected events or temporary
registrations, hold down the SHIFT button and press
the EXIT button.
6.
MENU/OPERATION button
MENU button
After entering the STOP status by pressing the STOP
button, press the MENU button to open the menu
window and press again to close it.
OPERATION (SHIFT + MENU) button
Hold down the SHIFT button and press the MENU
button to open OPERATION in the GUI menu.
7.
(TC PRESET)/PROP button
PROP (SHIFT + TC PRESET) button
Holding down the SHIFT button and pressing the TC
PRESET button performs the following functions
depending on the current operation.
• During recorder operation
Displays detailed information on the event at the cursor
location.
• During player operation
Displays detailed information on the clip at the cursor
location. However, the details that appear are the
same as those obtained by the properties on the left
side of the thumbnail screen in thumbnail mode.
Press the EXIT button to return to the normal screen.
➝Refer to "Viewing Event and Clip Information" (page
108).
8.
PLAYER/ SOURCE SELECT button
PLAYER button
Use this button to switch between player and recorder
operation. During player operation, the button lights
and the player screen is available. During recorder
operation, the button goes out and the recorder screen
and timeline become available.
SOURCE SELECT (SHIFT + PLAYER) button
Press this button and select a player from the devices
(interfaces) listed in the menu that appears. Select a
device with the cursor and press the SET button to use
it as the source player.
P2 CARD
Select to use a clip on a P2 card as
(default):
a player.
EXT PLAYER
Select EXT PLAYER to use an
<RS422>:
external device controlled via
RS-422A.
◆ NOTE:
• When the playlist format is 24PN or
30PN, you can only select the
corresponding value (24PN or 30PN)
in setup menu No. 25 (SYSTEM
FREQ).
USB HDD:
Select USB HDD to use a hard disk
connected via USB as a player
eSATA HDD:
Select eSATA HDD to use a hard
disk connected via eSATA as a
player
CANCEL:
Ends without making a selection.
*1: You must first use HDD EXPLORE to select partitions that
allow playback.
➝Refer to "Displaying Hard Disk Information (Explorer
Screen)" (page 118) and "Selecting partition or
folder as target" (page 119).
9.
RESET/NEW button
RESET button
Resets the CTL counter.
RESET + IN/OUT button
Hold down the IN/OUT button and press the RESET
button to reset the IN or OUT point for the player or
recorder, whichever is active.
NEW (SHIFT + RESET) button
Hold down the SHIFT button and press the RESET
button to create a new playlist (fulfils the same function
as [FILE] - [NEW]).
*1
.
*1
.
Editing: Playlist Function
83
Advertisement
Table of Contents
