Table of Contents
Advertisement
3
Press the EJECT button to eject the P2 card.
Preventing Accidental Deletion
Set the write-protection switch to [PROTECT] to prevent
accidental deletion of data recorded on a P2 card.
PROTECT
◆ NOTE:
• Switching the write-protection switch during recording, playback or
other access operation will not take effect until after these access
operations (playback, recording, etc.) complete.
For the latest information on P2 cards and
SD memory cards
For the latest information not available in the Operating
Instructions of P2 cards and SD memory cards, visit the P2
support desk at the following Web sites.
For English: https://eww.pavc.panasonic.co.jp/pro-av/
40
Introduction: Recording, Playback and P2 Card Handling
◆ NOTE:
• Removing a P2 card in the thumbnail screen automatically closes
• Do not remove P2 cards during access or during recognition
• The clips on a P2 card that was removed during access may no
• Removing a P2 card during formatting will in most cases destroy the
• In LAN mode, P2 cards must be available at all times and can
Write-protection
switch
the thumbnail screen.
directly after insertion (when the P2 card access LED flashes
orange); otherwise the P2 cards may be damaged. If a P2 card by
any chance is removed during access, [E-30] appears on the LCD
monitor and the LCD panel displays the [AUTO OFF] warning. All P2
card access LEDs will flash rapidly in orange. Turn off the power,
and then turn it back on.
longer be in the right order. Check the clips and perform the
necessary repair operation.
➝ For details, refer to "Repairing Bad Clips" (page 60).
formatting. Reformat the card after restarting the PC.
therefore not be removed. To remove a P2 card, return to the main
mode.
Advertisement
Table of Contents
