Operation - Panasonic AJ-HPM200 Operating Instructions Manual

OPERATION

This menu allows you to set method for engaging search dial operations, maximum shuttle speed operation, maximum speed
of FF and REW operation, NEXT and PREV seek operations, display of warning messages when REF.VIDEO is not connected,
PLAY delay time, battery type, display of warnings when power is too low, voltage when the power supply is turned off.
Item
FR SUPER
No. DISP.
100 SEARCH ENA
101 SHTL MAX
102 FF.REW MAX
103 SEEK SEL
104 REF ALARM
108 PLAY DELAY
122 STOP EE SEL
147 WFM DISP
166
Setup: Item Settings
Setting
FR SUPER
No. DISP.
0000 DIAL Specifies method for transferring to the search mode (search dial operation).
0: Press the STILL button or turn the search dial to engage search dial operation.
0001 KEY
1: Press the STILL button to engage search dial operation.
0000 ×8 Sets the maximum shuttle speed operation.
0001 16 0: 8× normal speed
×
1: 16× normal speed
0002 ×32
2: 32× normal speed
0003 ×60
3: 60× normal speed
0004 ×100
4: 100× normal speed
0000 32 Sets the maximum speed of FF and REW operation.
×
0: 32× normal speed
0001 ×60
1: 60× normal speed
0002 ×100
2: 100× normal speed
0003 SEEK
3: Seek operation to start of clip
NOTE:
• When SEEK is selected, FF and REW operations for FF and REW commands
transferred via 9P and 1394 are performed at 100× normal speed. Note that seek
operations initiated by the FF and REW commands via 9P behave differently when
ORIG is set in setup menu No. 202 (ID SEL). The cursor moves to left or right in
thumbnail screens.
• The seek operation is available in playback mode.
0000 CLIP Specifies where a NEXT (SHIFT+FF) and PREV (SHIFT+REW) seek operation moves to.
0: The start of the clip
0001 CLIP&T
1: The start of the clip or video text memo
NOTE:
This setting is not available during FF and REW operation.
0000 OFF
Selects whether or not a warning should appear when REF.VIDEO is not connected.
0: Displays no warning
0001 ON
1: Flashes the STOP lamp to warn
0000 0
Sets PLAY delay time in frame increments.
| |
0015 15
0000 EE Specifies whether to invoke the EE mode or playback mode when STOP is pressed.
0: EE mode
0001 PB
1: Playback mode
NOTE:
• During IEEE1394 signal input, the EE mode is invoked regardless of this menu
setting.
• Selecting PB displays a freeze picture of the last video for VIDEO OUT and SDI OUT
output during thumbnail display.
0000 OFF Selects wave form monitor (WFM) display mode.
0001 0: Not displayed
WAVE
0002
1: Waveform display
VECTOR
2: Vector display
NOTE:
The waveform monitor is not displayed when there is no input.
• XX indicates factory default settings.
Settings and brief function description