Dial Block/Wakeup Call Status Confirmation; Room Monitor; Attendant Call - NEC 1232 AK Series Operation Manual

Other Features
To cancel Wakeup Call:
(Extension No.10 only)

Dial Block/Wakeup Call Status Confirmation

The setting status of Dial Block and Wakeup Call at each extension can be confirmed at DSS console paired
with Attendant extension (No.10).
To check the status of Wakeup
(Extension No.10 with
DSS console)

Room Monitor

Room Monitor lets one extension monitor (listen to) the sounds in a room containing another extension.
To activate Room Monitor at
Monitored extension:
Note) KTS can be monitored by only KTS in another method. Refer to "Room Monitor" on Page 39.
To activate Room Monitor
at monitoring extension:
To cancel Room Monitor

Attendant Call

Attendant Call allows extension user to call attendant extension by dialing a single digit.
To place an Attendant
Note: In case, the SLT user cannot access some features after lifting handset.
72
1. Press
2. Press
3. Dial extension No. (e.g. 12)
4. Press
5. Press
6. Return to the idle condition automatically.
1. Lift handset.
2. Dial function code.(e.g. 959 or 059)
3. Hang up.
1. Press
call and Dial Block:
2. Press DSS key. The display shows the status.
3. Press
1. Off-hook condition. (Busy tone is heard.)
1. Lift handset.
2. Dial the monitored SLT extension No. (Busy tone is heard).
3. Press
1. Replace the handset.
at monitored and
monitoring extension:
1. Lift handset or press
2. Press
Call:
1. Lift handset.(Intercom Dial Tone shall be heard.)
2. Press
OPAC
key.
9 .
#
∗
to accept.
to cancel the pre-set time. (1 short beep tone
∗
shall be sent.)
CHECK key.
CLEAR
key to return to the idle condition.
2 .
SPK
.
0
or .
0 9
.