Default D-Link Access Point Settings; Default D-Link Access Point Profile Settings; Table 86: Default Ap Settings; Table 87: Ap Profile Default Settings - D-Link DWS-3000 Series User Manual

D-Link Unified Access System
D D-L A
EFAULT INK
Table 86 shows the default D-Link Access Point settings. The settings are the same for DWL-3500AP, DWL-8500AP, and
DWL-8600AP.
Feature
System Information
User Name
Password
Network Information
DHCP Client
Management IP Address
Subnet Mask
Management VLAN
Untagged VLAN
D D-L A
EFAULT INK
Table 87 shows the AP settings for the default profile. By default, when a D-Link Access Point associates with the switch,
the settings in this table are assigned to the AP upon successful AP validation.
Note: Only the settings for Radio 2 will be applied to DWL-3500APs if they are managed by a DWS-3000 switch.
Feature
Radio Settings
Radio (1 and 2) State
Radio 1 IEEE 802.11 Mode
Radio 2 IEEE 802.11 Mode
Super AG
RTS Threshold
Load Balancing
Load Utilization
RF Scan Other Channels
RF Scan Interval
RF Scan Sentry
Station Isolation
Page 204
P S
CCESS OINT ETTINGS

Table 86: Default AP Settings

P P
CCESS OINT ROFILE

Table 87: AP Profile Default Settings

Default
admin
admin
Enabled
10.90.90.91 (If not assigned by DHCP)
255.0.0.0 (If not assigned by DHCP)
1
1
S
ETTINGS
Default
On
802.11a
Note: If the AP operates in a regulatory domain where 802.11a is
not supported, the radio is disabled and no mode is configured.
802.11b/g
Disabled
2347 bytes
Disabled
60%
Disabled
60 seconds
Disabled
Disabled
Software User Manual
02/15/2011
Document 34CS3000-SWUM104-D10