Managing Failed Or Rogue Aps - D-Link DWS-3000 Series User Manual

D-Link Unified Access System
4 Enter the IP address of the RADIUS server to use for the valid AP database and click Submit.
Additional fields appear.
5 Configure information that the Unified Switch must use to contact the RADIUS server on your network, such as the
shared secret.
6 Click Submit to apply your changes.
The following example shows how to configure RADIUS authentication by using the CLI:
1 Enter the Wireless Config mode.
(switch-prompt) >enable
Password:
(switch-prompt) #config
(switch-prompt) (Config)#wireless
2 Set the RADIUS server as the validation method.
(switch-prompt) (Config-wireless)#ap validation radius
3 Exit to Global Config Mode and configure the RADIUS settings.
In the following command example, the RADIUS server IP address is 192.168.2.2.
(switch-prompt) (Config-wireless)#exit
(switch-prompt) (Config)#radius server host auth 192.168.2.2
(switch-prompt) (Config)#radius server key auth 192.168.2.2
Enter secret (16 characters max):******************
Re-enter secret:******************
For information about configuring additional RADIUS parameters by using the CLI, see the D-Link CLI Command Reference.

Managing Failed or Rogue APs

If an AP attempts to contact a switch but the authentication fails or if the MAC address of an AP is not in the Valid AP
database, AP Validation fails and the AP appears in the list on the Authentication Failed Access Points page. If the switch
Page 74
Software User Manual
02/15/2011
Document 34CS3000-SWUM104-D10