Figure 37: Mac Access Control; Table 10: Mac Authentication - D-Link DWS-3000 Series User Manual

D-Link Unified Access System
Note: The MAC list label updates depending on the default action you select.
To add a wireless client to the MAC Authentication list, enter the MAC address of the client in the MAC Address field and
click Add. You must click Submit to apply the changes.
• Click Clear to reset the page to the default values.
• Click Refresh to update the screen with the most current information.
• The Next button appears on this page when it is opened through the Administration > Basic Setup page. Click Next
to navigate to the Wireless Default Radio Configuration page.
The following table describes the MAC Authentication fields in more detail.
Field
Default Action
Allow MAC List
Client MAC Address
Page 80

Figure 37: MAC Access Control

Allows only MAC
addresses that
appear in the list
Denies only MAC
addresses that
appear in the list

Table 10: MAC Authentication

Description
The default action is the action that is taken for unknown MAC
addresses of wireless clients that attempt to associate with an
access point.
• Allow—Only the clients you explicitly add to this list are allowed
access to APs that use MAC Authentication.
• Deny—Only the clients you explicitly add to this list are denied
access to APs that use MAC Authentication.
This list shows the MAC address of the wireless clients that have
already been added to the list of wireless clients to allow or deny
access to the APs.
Enter the MAC address of the wireless client to allow or deny
access to all APs that use this profile.
Software User Manual
02/15/2011
Document 34CS3000-SWUM104-D10