Figure 11.18 [Virtual Memory] Dialog Box - Fujitsu PRIMEQUEST 2000 Series Administration Manual

CHAPTER 11 Error Notification and Maintenance (Contents, Methods, and Procedures)
11.4 Collecting Maintenance Data
6. Uncheck [Automatically manage paging file size for all drives]. [Drive] specifies the drives on which
paging files are created.
The selected drive under [Drive] of [Paging file size for selected drive] is displayed.
Notes
- No dump files and paging files can be stored at the iSCSI connection destination during internal disk
boot and SAN (FC) boot.
- The file system for ReFS volumes cannot store paging files.
7. Select [Custom size], and enter a value in [Initial size].
The specified size must be greater than the size of mounted memory plus 1 MB in order to acquire
memory dumps normally. The recommended size is approximately 1.5 times the size of mounted memory.
Notes
- Check [Automatically manage paging file size for all drives].
- Select [System managed size].
8. Enter a value in [Maximum size].
Specify a value that is the same as or larger than [Initial size]. The recommended size is the same as
[Initial size].
9. Save settings.
Click [Set] under [Paging file size for selected drive].
The settings are saved, and [Paging File Size] of [Drive] displays the set values.
10. Click the [OK] button to close the [Virtual Memory] dialog box.
The message [You must restart your computer to apply these changes] appears. Click the [OK] button to
close the message box.
11. Click the [OK] button to close the [Performance Options] dialog box.

FIGURE 11.18 [Virtual Memory] dialog box

234
C122-E175-02EN