Procedure Of Expansion In Hot Maintenance - Fujitsu PRIMEQUEST 2000 Series Administration Manual

CHAPTER 3 Component Configuration and Replacement (Add, Remove)
3.4 Expansion of components
Component name
PCI Express card
DU
PCI Express card
FBU
HDD/SSD
MMB (*3)
OPL
MP, PDB
PCI_Box (*3)
IO_PSU
IO_FAN
PEXU
- : Outside the expansion target
*1: PCI hot plug function is required
*2: DR function is required
*3: For only PRIMEQUEST 2400E and 2800E.
Perform the license authentication following the Windows window instructions.
Windows license authentication
1. When starting Windows, click the balloon for license authentication that is displayed in the task tray.
2. Click [Product Key Input] and enter the product key found on the COA label attached to rear lateral side
of the cabinet..
3. License authentication can be performed via the Internet or by making a phone call to the Microsoft
customer service center.
Hot add procedure for HDD/SSD
For details on the hot add procedure for HDD/SSD, see
Changing the firmware when expanding components
The firmware may be required to be changed when expanding a component.
Use the same firmware version number of the FC (Fiber Channel) card within the same partition.
- FC card (PCI Express card)
Use the same version number as the firmware version number that is currently in use.
How to confirm the firmware number
After adding a card, and the partition is started, use the following procedure to confirm the firmware version
number.
How to confirm the FC card firmware version number
To confirm the version number, see '1.2.14 [IOU] menu' or'1.2.16 [PCI_Box] menu' in the "PRIMEQUEST
2000 series Tool Reference' (C122-E177).
Changing the firmware
If the firmware version numbers are not identical, change the firmware.
The information on the firmware and the procedure are provided in the following website.
Download of drivers and the bundled software of the PRIMEQUEST 2000 series.
http://support.ts.fujitsu.com/
Remarks
In the PRIMEQUEST 2000 series, the customer will change a part of the firmware.

3.4.1 Procedure of expansion in hot maintenance

This section describes the procedures before and after expansion in hot maintenance.
Procedure before expansion
AC power off
(Device stop)
Expandable
Expandable
Expandable
-
Expandable
Expandable
-
-
Expandable
Expandable
-
-
PCI Express Expandable
card
AC power on
All partitions off Target partition
(hot
maintenance)
Expandable Expandable
Expandable Expandable
Expandable Expandable
- -
Expandable Expandable
Expandable Expandable
- -
- -
Expandable Expandable
Expandable Expandable
- -
- -
Expandable Expandable
CHAPTER 6 Replacement of HDD/SSD.
53
AC power on AC power on
Target partition
off (hot on (hot
maintenance) maintenance)
Not expandable
Not expandable
Not expandable
-
Expandable
Expandable
-
-
Not expandable
Expandable
-
-
Expandable (*1)
C122-E175-02EN