Acquiring Data For Investigation (Rhel); Figure 11.20 [Virtual Memory] Dialog Box - Fujitsu PRIMEQUEST 2000 Series Administration Manual

CHAPTER 11 Error Notification and Maintenance (Contents, Methods, and Procedures)
11.4 Collecting Maintenance Data
6. Specify the drive on which to create the paging file.
Select the system installation drive in [Drive].
[Drive] in [Paging file size for selected drive] displays the selected drive.
7. Select a value in [Custom size]. Enter a value in [Initial size].
To correctly acquire a memory dump, the specified size must be equivalent to the size of mounted
memory plus 1 MB or more. About 1.5 times the size of the mounted memory is recommended.
8. Enter a value in [Maximum size].
Be sure to specify a value larger than or equal to [Initial size]. The same size as [Initial size] is
recommended.
9. Save the settings.
Click [Set] in [Paging file size for selected drive].
This saves the settings. [Paging file size] in [Drive] displays the entered values.
10. Click the [OK] button to close the [Virtual Memory] dialog box.
11. Click the [OK] button to close the [Performance Options] dialog box.
12. Click the [OK] button to close the [System Properties] dialog box.
13. Restart the partition.
After the partition restart, the settings take effect.

11.4.4 Acquiring data for investigation (RHEL)

If a problem occurs in RHEL, data on the situation is required for ensuring a prompt and correct investigation.
For details on setting of dump environment, contact the distributor where you purchased your product, or your
sales representative.

FIGURE 11.20 [Virtual Memory] dialog box

236
C122-E175-02EN