Cli: Configuring Radio Settings - HP 530 Management Manual

N o t e
N o t e

CLI: Configuring Radio Settings

CLI Commands Used in This Section
Command Syntax
description <string>
[no] basic-rate <value>
beacon-interval <value>
fragmentation-thresh <value>
rts-threshold <value>
show stations
show radio <radio>
You must set the country code before configuring the radio settings. These
basic settings affect the radio channels and values that are available for other
parameters. See
"Setting the Country Code" on page 6-4
command to save the setting.
Configuring One Radio. The following example details how to enable one
radio and configure specific radio parameters on the access point.
Enter radio commands one line at a time.
.
ProCurve Access Point 530# configure
ProCurve Access Point 530(config)# radio 1
ProCurve Access Point 530(radio1)# description "Radio 1 -
802.11g"
ProCurve Access Point 530(radio1)# beacon-interval 102
ProCurve Access Point 530(radio1)# fragmentation-thresh 1024
ProCurve Access Point 530(radio1)# rts-threshold 2000
Wireless Interface Configuration
Configuring the Radio
CLI Reference Page
9-117
9-107
9-109
9-112
9-114
9-123
9-117
. Use the write mem
6-21