Wep-Key (Wds) - HP 530 Management Manual

Command Mode
WDS Interface Configuration
Example
ProCurve Access Point 530(wds1)# show wds 1
WDS # 1
Description WDSLINK
Status Enabled
Local MAC 00:14:03:A2:4F:DE
STP State forwarding
Security Type no-security (from WLAN 1)
hex
WEP Key not set
128bit
WPA Key goodsecret
Bytes Rx
Packets Rx
Compressed Rx
Mcast packets Rx
Dropped Rx packets
FIFO overflows Rx
Frame errors Rx
Total Rx errors
ProCurve Access Point 530(wds1)#

wep-key (wds)

This command defines the wep-keys used for data encryption on an WDS
interface.
Syntax
wep-key <key>
key - Sets the character string for security. The number of characters
•
depend on the number of characters required for each WEP key
depends on the Key Length and Key Type settings:
– If Key Length is 40 bits and the Key Type is "ASCII", then each
WEP key must be five (5) characters long.
– If Key Length is 40 bits and Key Type is "Hex", then each WEP key
must be 10 characters long.
– If Key Length is 104 bits and Key Type is "ASCII", then each WEP
Key must be 13 characters long.
Wireless Distribution System (WDS)
Use Radio
Remote MAC 00:0D:9D:C6:98:7E
WDS SSID
0 Bytes Tx
0 Packets Tx
0 Compressed Tx
0 Carrier errors Tx
0 Dropped Tx packets
0 FIFO overflows Tx
0 Packet collisions Tx
0 Total Tx errors
Command Line Reference
1
marge
WEP Key Type
WEP Key Size
0
0
0
0
0
0
0
0
9-163