Web Authentication Commands - HP 530 Management Manual

Web Authentication Commands

The commands described in this section are used to enable and configure Web
Authentication (Web-Auth) in the Access Point 530.
Command
Global
[no] web-auth
[no] web-auth starting-ip-address <ip-
address> <subnet-mask>
web-auth lease-time <ip-address>
[no] web-auth guest-username
<username>
[no] web-auth guest-password
<password>
show web-auth
Per WLAN
login
[no] web-auth guest-
login
[no] web-auth username-
[no] web-auth redirect-url
<retries>
web-auth retry-limit
Command Line Reference

Web Authentication Commands

Function
Enables 802.1X authentication
using a Web-browser interface
on the access point.
Specifies the first IP address and
subnet mask that define the pool
of temporary IP addresses used
for initial Web-Auth connections.
Specifies the period in seconds
of the IP lease for the pool of
temporary Web-Auth addresses.
Specifies the username that will
be used for Guest user logins
using Web-Auth.
Specifies the password that will
be used for Guest user logins
using Web-Auth.
Displays the current Web-Auth
settings.
Enables or disables Web-Auth
for Guest users on the selected
WLAN.
Enables or disables Web-Auth
for Registered users on the
selected WLAN.
Specifies the URL the user is
redirected to following
successful Web Authentication.
Specifies the number of failed
login attempts (from 1 to 9) a user
may make before logins are
refused by the access point.
Default is 3 attempts.
Mode Page
IC-R- 9-82
WLAN
GC 9-80
GC 9-80
GC 9-81
GC 9-81
MC 9-85
IC-R- 9-82
WLAN
IC-R- 9-82
WLAN
IC-R- 9-82
WLAN
IC-R- 9-82
WLAN
9-79