Warehouse Case 2 - Adaptive Mode Ap + Clients; Settings; Results With Adaptive Mode Ap + Clients - HP 530 Management Manual

Warehouse Case 2 – Adaptive Mode AP + Clients
Now consider the exact same configuration as in Case 1, except that now the
Warehouse APs have been configured with Adaptive Mode set to "AP+Clients".
AP #1
Channel
wlan-1 SSID public
wlan-2 SSID internal
Enabled
RF Group Name storage 1 storage 1 storage 1 storage 1 storage 1 storage 1
Avoid Other WLANs Disabled
Max Power Reduction 18 dB
Adaptive Mode AP+Clients AP+Clients AP+Clients AP+Clients AP+Clients AP+Clients

Settings

Adaptive Mode – The only difference between Warehouse Case 1 and 2 is
that Adaptive Mode has been set to "AP+Clients" on all APs in Case 2.

Results with Adaptive Mode AP + Clients

In this case, beacons and data are set to different power levels as follows:
■ Beacon power levels – Beacons are transmitted with no power reduc-
tion, other than the overall Tx Power Reduction control, which is not part
of .
Data power levels – Data transmissions are attenuated to minimize co-
■
channel interference with the closest AP, but attenuation will decrease
further (that is, higher transmit power) to maintain connection with the
associated station with the lowest RSSI. That is, the AP will always
attempt to maintain a connection with a client that might otherwise be
out of range.
AP #2 AP #3
1 6 11
public public
internal internal
Enabled Enabled
Disabled Disabled
18 dB 18 dB
Adaptive Tx Power Control Use Cases
Use Model: Warehouse Deployment
AP #4 AP #5
1 6
public public
internal internal
Enabled Enabled
Disabled Disabled
18 dB 18 dB
AP #6
11
public
internal
Enabled
Disabled
18 dB
C-9