Table 5-14 Maximum Number Of T-Point Isdn Primary Rate Interface Cards Per System; Table 5-15 Switch Setting For Sw2 On Pri/23 Card - Panasonic DBS 576 Technical Manual

Section 300-Installation
Table 5-14. Maximum Number of T-Point ISDN Primary Rate Interface Cards Per System
System Type
96 ports (CAB96 1)
x
192 ports (CAB96 + CAB96B)
288 ports (CAB96 + CAB96B
384 ports (CAB96 2 + CAB96B
x
480 ports (CAB96x2 + CAB96Bx3)
576 ports (CAB96x2 + CAB96Bx4)
Installation
1. Align the CN8 connector of the CPC96 card or the CN5 connector of the
2. Insert the CPC96, TSW288, or TSW576 card in the specified slot.
3. Set the DIP switch (SW2-1) of the PRI/23 card ON (trunk).
4. Set the DIP switch (SW2-2) of the PRI/23 card as shown in Table 5-15.
Table 5-15. Switch Setting for SW2 on PRI/23 Card
Switch No. Function
SW2-1 ON
OFF
SW2-2 ON
OFF
5. Set SW1 on the PRI/23 card according to the following table.
576-13-300
2)
x
2)
x
TSW288 or TSW576 card with the holes of spacers and connect the SYNC
synchronization package. See Figure 5-8 on page 5-20 for how to install the
SYNC synchronization package.
Set to "Trunk". for T-point.
Set to "extension". for S-point.
Set to "Other mode". Can be used with the programmed number (1 to
16B+D or 1 to 23B+D) of channels.
Set to "8-channel mode". Can be used with 1 to 8B + D channels.
These switch settings correspond to the distance between the DBS 576
and the CSU. To turn a switch on, set it to the "up" position.
DBS 576 (USA), issued 6/2/98
Chapter 5 - Trunks and Extensions
Maximum Cards
(available flexible
slot positions)
3/(1, 5, 9)
6/(1, 5, 9 2)
X
9/(1, 5, 9 3)
X
12/(1, 5, 9 4)
X
15/(1, 5, 9 5)
X
18/(1, 5, 9 6)
X
Maximum Lines
(No. of channels)
3/(72ch)
6/(144ch)
9/(216ch)
12/(288ch)
15/(360ch)
18/(432ch)
5-23