Pc Customization Tool; Table 6-3 Rs-232C Port (Cn5 And Cn6) Pinout Of Scc Card - Panasonic DBS 576 Technical Manual

Section 300-Installation

PC Customization Tool

Guidelines
• You can connect a PC to an SCC card in an optional card slot to customize the
• SCC cards cannot be installed and removed while the cabinet is operating. First,
• If you are using a PC for customizing the setup, a Windows
• Prepare an RS-232C cable.
• To send data from a PC to the main unit, you will need not only the PC
• Table 6-3 shows the pinout for the RS-232C port (CN5 and CN6) of the SCC
Table 6-3. RS-232C port (CN5 and CN6) pinout of SCC card
Connector pin No.
Making an RS-232C Cable
Depending on the RS-232C connector on your PC, you will need to make one of the
following RS-232C cables.
• D-SUB 9-pin to D-SUB 25-pin
576-13-300
setup without using a telephone for customization.
turn the power off.
required:
customization software but also Windows and a 3.5-in. 2HD floppy disk
(formatted for Windows
card.
Signal
1
2
3
4
5
6
7
8
9
• If your PC is equipped with a 25-pin D-SUB RS-232C connector, make a
cable as shown in Figure 6-4. The cable should be less than 50 ft. (15m) long.
DBS 576 (USA), issued 6/2/98
®
) for saving the customization data.
IN/OUT
CD -
RD IN
TD OUT
DTR OUT
SG -
DSR IN
RTS OUT
CTS IN
FG -
Chapter 6. Peripheral Equipment
SCC card
®
-based computer is
Description
Not used
Receive data
Send data
Ready signal from PBX
Signal ground
Data set ready
Request to send
Clear to send
Not used
6-7