Section 300-Installation
Wall Mounting Installation
Figure 3-6. Cabinet plywood mounting backboard
1. Attach wall-mounting brackets on the rear of the cabinet as shown in the figure
Figure 3-7. Wall-mounting Installation: Attaching the Wall-mounting Bracket
576-13-300
Prior to mounting the DBS 576 to the wall, the plywood mounting backboard
must be prepared as follows:
• Use 1/2" or larger plywood sized for the complete DBS 576 system.
• Secure the board to the wall with at least four #10 1 3/4" sheet metal screws
for a single cabinet system. Each screw must be installed to the metal studs.
• Two or more additional screws should be installed into the metal studs for
each additional cabinet to support the additional weight.
below.
DBS 576 (USA), issued 6/2/98
Chapter 3. Cabinet Installation
3-7