Panasonic 308 Installation Instructions Manual page 141

_. DBS
FF-2 Trunk mode
FF2-(1 32)# lO#k:$?
- - -
Connected phone line type setting
Asthe dialing decision for TRS and the like is
affected if the system is connected to a PBX,
either a PBX line or a CO. line is set for each trunk
l#: CO. line
2%: PBX line (Need to access numberto CO line)
FF2-(l- 32)Pl l#-(0 or l)#
DISA Ijne setting
(Automatic DISA answer)
This setting is each trunk port to receive incoming
calls using the DISA functionHowever you may
need to set DISA start and end times to each trunk.
OR: Does not answer DISA incomino calls
l#: Answers DISA incoming calls and also
accommodates outgoing calls from DISA
FF2-(1 - 32)#-12#-(01 - 72)#
Private line setting (Private outside line)
Each extension can have an exclusive private line
which can be set when programming.
An incoming call from a trunk line set for private
use rings on the extension to which that line'
belongs only.
While there can be a number of private lines
belonging to one telephone, a single private line
cannot belong in common to a number of
telephones.
Once set, other extensions can not make calls to or
receive calls from that trunk port number, and
even if the private trunk line setting is canceled it
is not make calls or receive calls automatically.
In this case set TRS and RING separately.
SECTION 400 (Version 3.0)
Issue 1 January 1990
FF2-(1- 32)#-13#-(0 - I)#
Auto pause function setting.for PBX line
It is set whether or not a auto pause for each
dialing done with the system setting is necessary
or not
0#: Auto pause for each dialing not necessary
1 R: Auto cause function for each dialina
FF2-(1- 32)#-14#- (0 or 1)s
Dialing tone detection setting
It is set whether or not the dialing tone is to be
detected when making an outside call.
If it is set, the number dialed is not transmitted to
the out- side line until the dialing tone has been
detected.
If it is not set, the number dialing is out in
accordance with the setting for the system timer.
O#:Need the dialina tone for the dial out
1 #:No dial tone detection (Free dial)
FF2-(1- 32)#- 15#-( 1 - 3)#
DTMF dial signal sending time
The length of time for sending the signal is
changed in cases where a DTMF dialing signal is
sent to
an
outside line, and where the sending
time for the DTMF signal is short and it does not
operate when receiving the MCl or SPRINT line or
various services.
l#: 75ms ON / 50ms OFF
2#: 125ms ON I 125mr OFF
3#t: 250ms ON / 250ms OFF
lCONF]#: No orivate line
(01 - 72)#: Private line for set extension port
-3o-