Panasonic 308 Installation Instructions Manual page 145

DBS
FF-3 Extension mode
SECTION 400 (Version 3.0)
Issue 1 January 1990
FF3-(1- 72)#-3#-(01- 72)#
EM/24 user-port number
Extension ports are stored for operating
extensions connected to them and for the
connected EM/24 console and stored.
ICONFIR: EM/24 not connected
(01 - 72)#: Operates as EM/24 for stored extension
Note : As regards EM124, after they have been
stored, it is necessary either to tom the
system power off and then turn it on again,
or to disconnect the module jacks for EM124
and then insert them once more.
FF3-(l - 72)#4#-(0 or 1)#
Forced Least Cost Routing restriction
This setting is for specifying that outside calls
made from extensions must be through LCR
The sening is such that, while managers and the
like can use another line when the LCR line is busy,
other staff members must use LCR for making calls
at all times. When LCR calls are made from set
extensions by dialing 9, it is possible to restrict
them.
OB: Outside calls need not be made bv LCR
1#: Outside calls must be made by LCR '
FF3+ - 72)#-S#-(O or I)#
Account code TRS setting
This setting is so that outside calls cannot be made
from the extensions programmed for this if the
account code is not entered.
O#:No account code TRS function
l#:Orderto ID code for making outside line call
FF3-(1- 72)#-6#- (0001 - 9999)#
Station lockout key code storing
If you do not want other people to make,outside
calls from your extension when you leave at your
extension, this functions can be prevented.
A key code is stored for each extension, and this
key code is input to cancel the station lockout
function upon returning to ones desk.
Key codes can be stored within the range of 0000
- 9999 and deleted by inputting [CONF].
. ICONFIB: No station lockout function
(0000 - 9999)f: Storing station lockout key code
FF3-(1- 72)#-7#-(0 or l)#
Off-book signal setting
It is stored for each extension whether a signal
indicating an incoming call on an outside line is to
be sent while the extension is-busy. Even if set for
this, however, this signal will not be sent during a
conference call, while the extension is on hold, or
during a call on a outside line for which there is no
tine key on the telephone.
Extension Port 1,2 (Attendant tel)
,O#: No incoming ring when phone is busy
18: Have the incomino rino when phone is busy
Another pon
O#:No incomina rino when phone is busy
l#:Have the incoming ring when phone is busy
Note 1.: For the incoming w/i signal, the off-
hooksignal volume and off-hook
signaiing pattern are set separately.
When off-hook signal setting is done,
hunting function is not available.
-34-