Hdmi Connection - Silvercrest SSR 1080 A1 User Manual And Service Information

Digital HD Satellite Receiver SSR 1080 A1
In order to open the advanced menu you may need a password. The factory-default
password is: 0000.
If no hard disk information is shown, you will need to format the hard disk with a compatible file
system for your satellite receiver. To do this, press the Menu button (22) and then press the
navigation buttons (23) to select the "Expert Mode" item and finally select "Media". Select the "HDD
Format" item. Next press OK (34) to confirm and another window opens. If the hard disk is divided
into multiple partitions, you can choose which partition should be formatted. Select the option "HDD
Format" and press OK (34) to confirm the start of formatting. A safety prompt will appear. Select
whether you want to format your hard disk using the "FAT" or the "NTFS" file system, or select
"Cancel" to cancel.
CAUTION! Formatting the hard disk will erase all data stored on it. After the hard
disk has been formatted, press the EXIT button (33) to quit the menu and then select
"HDD Information". Here you can display the available storage on the hard disk. To
avoid any loss of data, you should never disconnect the hard disk from the satellite
receiver while the devices are on. First switch the satellite receiver to Standby mode
before disconnecting the hard disk.
Targa does not assume any liability for loss of data or damage resulting from
the use of the USB interface.
The total recording time depends on the size of the hard disk but also on the recorded programmes.

HDMI Connection

Use an HDMI cable to connect your satellite receiver to the TV set. This connection type guarantees
an optimum and loss-free transmission of the video and audio signals to the TV Set. As soon as a TV
set is connected to the satellite receiver using an HDMI cable, your satellite receiver will toggle
automatically to the HDMI signal output.
You can press the MODE button (37) to optimise the screen resolution for HDMI mode. Please note
that the picture may disappear when switching the resolution. So that you are aware of the current
resolution setting, the resolution will be shown briefly on the display (7) of the device (e.g. 480i,
720P, 1080). For optimum resolution on a modern flat-screen display we recommend using the
1080i_50 or 720p_50 setting.
When establishing this connection type, we recommend that you use both a SCART (Euro AV) as
well as an HDMI cable, as many TV sets do not have the HDMI input enabled by default. Via the
conventional SCART cable you will always be able to access the setup menus and customise
settings if no picture appears on the display.
Video and Audio Signal Connection:
All required settings can be found in the section "System Setup" (see page 25).
English - 12
or