Table of Contents
Advertisement
Available languages
Available languages
Defect
The disc is dirty.
Distorted or
flickering
The disc is scratched.
picture
The disc is warped.
There are no batteries in the remote.
The batteries have run out.
The remote is not directly pointing at the
remote sensor on the front of the machine.
The remote
does not work
The remote is out of range of the machine.
The machine is locked.
symbol
The wrong function has been selected.
appears on the
screen
Technical Data
Supported disc formats:
Video Format:
Audio Format:
Signal Output:
Outputs:
Inputs:
Power supply:
Max. Power consumption:
Frequency response:
Signal/Noise ratio for Audio-Signal:
Operating Conditions:
Please note that the system does not support some MPEG4 discs with the formats: *.rm/*.ra/*.ram/*.rmm. Take this
into account before buying discs.
The technical data serves only as a reference and may be changed without notice.
Cause
DVD, VCD, CD, MP3, DVCD, SVCD, CD-R, MPEG4
MPEG2 for DVD and MPEG1 for VCD
MPEG1, MPEG2, PCM, Stereo
Video Format: PAL, NTSC, AUTO
Video Output: 1.0Vp~p
Audio: Stereo, 1 ~ 2V (RMS)
Video- Output:, Audio- Output:,
OPTICAL OUTPUT, Component Output
COAXIAL OUTPUT and SCART OUTPUT
USB, Mutimedia memory card
~ 220-240V/50Hz
25W
20Hz-20KHz
≥
80 dB
Temperature: 5 °C ~ 35 °C
Installation: on a flat and level surface
Solution
Remove the disc from the disc tray and clean
the disc.
Use a different disc.
Insert 2 batteries into the battery compart-
ment.
Replace both batteries.
Point the remote directly at the remote sensor
on the front of the machine.
The coverage of the remote is NO MORE THAN
7 METRES to the remote sensor on the front of
the machine.
Switch off the machine and disconnect it from
the mains. Then connect the machine again to
the mains and switch it back on.
Refer to the user manual.
± 3dB
English
109
Advertisement
Chapters
Table of Contents
