Hitachi L-2100 Instruction Manual page 54

(b) In case that an event setting is desired independent of FLOW , only the event
code showed be entered. Press ENTER to skip all the entries you do not
want until you reach event column.
In the SET PROGRAM mode, the interpolation of mixing ratio, flow rate, etc. that
occurs in a time program is as follows.
Parameter
Interpolation
T , T : Preset time
N N+1
NOTICE: For generating a stepwise gradient program, utilize T
Flow Rate
Linear
T T
N N+1
4 - 10
3.9
- T = 0.1.
N+1 N