Programming Operation - Hitachi L-2100 Instruction Manual

4.1.2

Programming Operation

This section discusses the programming of the FLOW mode.
An example is given where upper pressure limit is 20.0 MPa,
lower pressure limit is 0 MPa, analysis time is 0 min, flow rate is
1.0 mL/ min.
PROGRAM No.
PRESSURE VALUE
TIME FLOW
(min) (ml/min)
0.0 1.000
Monitor screen
If manual setting screen is displayed, press INITIAL to
obtain the programming mode.
PROG
Program generation is started.
SET PROGRAM:
<1-9> 1
Input program No. Valid program numbers are from 1 to
9.
MODIFY=0, NEW=1
0
Generates a new program or modifies an existing
program.
4 - 3
= 1
: MAX MIN
20.0 0.0
EVENT
1 2 3
12 22
No.
MPa
4
32 42
[--]
[--]