Hitachi L-2100 Instruction Manual page 60

1 Program number can be from 1 to 9.
2 For editing, input 0. For generating a new program, input 1.
3 If pump pressure rises beyond the level set here, the pump automatically stops.
.
4 If pump pressure falls below the level set here, the pump automatically stops. The
.
5 Input the time point of the step you want to add.
6 Flow rate valid entries are from 0.00 to 2.499 (L-2100). Flow rate valid entries are
from 0.00 to 9.999 (L-2130).
7 Input the event code. At the set time point, you can stop the pump, generate an
audible signal, markers, times, etc. When properly interfaced, these signals can be
output to an external system. No display will show on the screen unless an event is
set.
4 - 16