Procedure Overview - Panasonic KX-NCP0158 Quick Installation Manual

2 Procedure Overview

2 Procedure Overview
When connecting the wireless system, use extreme care in conducting the site survey. Site surveys can be
conducted using the KX-TD7685/KX-TD7695/KX-TD7696 PS. An incorrectly performed site survey can result
in poor service area, frequent noise, disconnection of calls, and synchronization failure for CSs.
Notice
•
When installing the DECT 6.0 wireless system in an area where another wireless system (2.4 GHz) is
already installed, it is necessary to reconduct the site survey to find the optimum position for the CS.
If you install the new CS in the same position as the old CS, it may result in a poor service area, frequent
noise, and disconnection of calls.
•
In this case, it is necessary to perform system initialization. For details about the system initialization
procedure, refer to "Starting the PBX" in the Installation Manual for your PBX.
1. Investigate the installation site
Refer to "3 Site Planning".
a.
Obtain a map of the CS installation site.
b.
Identify the service area required by the user on the map.
c.
Plan the location of each CS, taking account of distance, building materials, etc.
2. Prepare for site survey
Refer to "4 Before Site Survey".
a.
Check and assign the CS ID number to the PS.
b.
Assign a channel number to each CS by setting the DIP switches on the back of the CS.
c.
Supply electricity to each CS using an AC adaptor or by connecting them to a PoE hub/PoE adaptor.
d.
Install each CS temporarily as planned.
Note
•
Install at least 2 m (6 ft 7 in) above the floor.
•
Place the antennas so that they are pointing in directions that are 90 degrees apart (for antenna
diversity).
3. Conduct the site survey
Refer to "5 Site Survey Using the KX-TD7685/KX-TD7695/KX-TD7696".
a.
Test the radio signal strength using the PS.
Confirm that the radio signal strength level is "12" near the CS.
Using the KX-TD7685/KX-TD7695/KX-TD7696
Press 1, 9, and POWER
for more than 2 seconds.
b.
By walking away from the CS with the PS, check the radio signal strength. The radio signal strength
weakens as you walk away from the CS.
c.
Map the CS coverage area at radio signal strength levels "03" and "07".
14 Quick Installation Guide
Display example:
To survey
specific channel
RADIO STRENGTH
<<< MEASURING >>>
Channel No.
0 to 4
RADIO STRENGTH
CH0 SLOT:06 SYNC
L:12 0000/0100
CS-ID:9005301234
Document Version 2009-12