Panasonic KX-NCP0158 Quick Installation Manual page 45

Connecting an IP-CS to a LAN
When connecting an IP-CS to the LAN, connect it to a switching hub.
Note
•
Use an Ethernet straight cable with an RJ45 connector to connect the IP-CS to a switching hub. The
cable should be a 10BASE-T/100BASE-TX CAT 5 (Category 5) or higher cable, and the diameter of
the cable must be 6.5 mm or less.
•
It is possible to connect the IP-CS to the LAN while registering the IP-CS to the PBX. For details, refer
to "8 Registering IP Cell Stations".
1.
Connect the cable to the IP-CS.
2.
Pass the cable through the groove of the IP-CS in one of the following three ways.
1 1
To a Switching Hub
3.
Connect the other end of the cable to the switching hub.
Document Version 2009-12
Ethernet Straight Cable
2
To a
Switching
Hub
7 Connecting IP Cell Stations
3
To a Switching Hub
Quick Installation Guide 45