Panasonic KX-NCP0158 Quick Installation Manual page 46

7 Connecting IP Cell Stations
Connecting an AC Adaptor to an IP-CS
IP-CSs comply with the IEEE 802.3af Power-over-Ethernet (PoE) standard. If PoE is available on your network,
these IP-CSs can receive the necessary power supply from the network through the network cable. In this
case, no AC adaptor is needed for the IP-CSs.
However, if PoE is not available, you will need to connect an AC adaptor to the IP-CS.
WARNING
When installing or testing a product with an external AC adaptor, the AC adaptor should be plugged
into a wall outlet or floor-mounted AC outlet. Do not connect the AC adaptor to a ceiling-mounted
AC outlet, as the weight of the adaptor may cause it to become disconnected.
CAUTION
The DC jack cover poses a choking hazard. Keep the DC jack cover out of reach of children.
Note
•
Use only the optional AC adaptor KX-A421 (PSLP1662) for the IP-CS.
•
If the AC adaptor cord is not long enough for installation, use the DC extension cable (PQJA10200). If
the AC adaptor cord is long enough, it is not necessary to use the DC extension cable (PQJA10200).
1.
Remove the DC jack cover, and connect the AC adaptor cord or the DC extension cable (PQJA10200) to
the IP-CS.
Cover
2.
When using the DC extension cable (PQJA10200), connect the AC adaptor cord to the other end of the
DC extension cable (PQJA10200).
46 Quick Installation Guide
AC Adaptor Cord
DC Extension Cable
(PQJA10200)
AC Adaptor Cord
/DC Extension Cable
(PQJA10200)
Document Version 2009-12