Panasonic KX-NCP0158 Quick Installation Manual page 67

4.
Temporarily install the IP-CS at least 2 m above the floor, and place the antennas so that they are pointing
in directions that are 90 degrees apart (for antenna diversity), as follows:
45º
90º
45º
Notice
Be sure to install the Master CS at the center of the installation site.
Step 3 - Setting a PS for the Site Survey
Assign the CS ID number to the PS.
Press 1, 9, and POWER
for more than 2 seconds.
To the initial display
Step 4 - Site Survey
1.
Enter Radio Signal Test mode.
Press 1, 9, and POWER
for more than 2 seconds.
Note
When the error rate is 3% or more, measure the error rate at the same location at least 5 times. You
must disconnect the CS and then reconnect it to take each measurement. If the error rate is consistently
Document Version 2009-12
To enter letters
A: +
B: +
ABC
Display example:
RADIO STRENGTH
<<< MEASURING >>>
A Step-by-step Instructions for Easy Installation
C: + E:
ABC
D: + F:
DEF
CS ID No.
0 to 9 and A to F
RADIO STRENGTH
CH0 SLOT:06 SYNC
L:12 0000/0100
CS-ID:9005301234
Error Rate (%)
= Frame error/Frame counter × 100
Radio Signal Strength Level
+
GHI
+
JKL
Quick Installation Guide 67