Configuring Dns Server; Figure 6.3 Example Of [Date/Time] Window - Fujitsu PRIMEQUEST 2000 Series Installation Manual

CHAPTER 6 Work after installation

6.3 Configuring DNS server

- When alarm occurs in the time maintenance battery of the partition side.
Execute any of the following ways to adjust the time.
- Set the time manually from the MMB Web-UI
- Set the time by using the NTP client function of the MMB
Remark
Set the time on Operation System if NTP is not used.
Operations
1. Click [Networking configuration] – [Date/Time].
→ [Date/Time] window is displayed. For the details of [Date/Time] window, see "1.5.1 [Date/Time] window" of
PRIMEQUEST 2000 series Tool Reference (CA92344-0539).
2. Click [Enable] for [NTP].
3. Select [NTP Time Correction Mode].
4. Enter IP address of other NTP server.
NTP Server 1: Specify NTP server.
NTP Server 2: Specify NTP server is.
NTP Server 3: Specify Other (Tertiary) NTP server is.
5. Click [Apply] button.
MMB synchronizes with NTP server and time set in NTP Server 1 ~ NTP Server 3.
6. After few minutes click [Refresh] button and confirm whether the correct time is displayed.
6.3 Configuring DNS server
See "3.3.8 DNS Server Configuration", for configuration of DNS server.
FIGURE 6.3 Example of [Date/Time] Window
112
CA92344-0536-01