Set Up Of Telnet - Fujitsu PRIMEQUEST 2000 Series Installation Manual

CHAPTER 3 Work before Operating System Installation
3.3 Connection and Setting of MMB
2. The values are entered in [IP Address], [Subnet Mask] (
*
1: [Prefix Length] is entered at the time of [IPv6]. [Gateway address] is also entered at the time of [Gateway address].
3. Each item is entered by clicking [Enable] for [Interface] in [MMB#0 IP Address] or [MMB#1 IP Address]. Here, the
assigned Physical IP Address is specified.
4. [Apply] button is clicked when the required items are set up.
Notes
If an incorrect value of IP Address is set, MMB Web-UI is not displayed. In that case, the correct value is set by
connecting MMB console PC to the MMB COM port.
Remark
The Physical IP Address and the Virtual IP Address of MMB#0, and MMB#1 are set up in the same subnet.

3.3.7 Set up of telnet

MMB telnet is set up.
See "3.5 Storage of the configuration
The following condition must be satisfied in advance when field engineers perform the Maintenance tasks on this product.
- Video Redirection and Virtual Media are available.
For details on how to setup the procedure, see Chapter 1.3.6 [Console Redirection Setup] window in the PRIMEQUEST
2000 Series Tool Reference (CA92344-0539).
- SSH or Telnet is available.
For details on how to setup the procedure, see Chapter 1.5.4 [Network Protocols] window in the PRIMEQUEST 2000
Series Tool Reference (CA92344-0539).
Note
To set up telnet, log in to Administrator privileges.
*
1) of [Virtual IP Address]. Host name is also set up.
information" for the backup of set up information.
20
CA92344-0536-01