Table of Contents
Advertisement
1MRS757105 B
RER601/603
Technical Manual
GUID-4BEC2B3C-7F54-483E-946F-A4C8D54F7270 V1 EN
Figure 17:
Ethernet settings
Override Ethernet configuration by DHCP? If enabled, the device gets the IP
address and other related information from a local DHCP server. When enabled, all
other settings are disabled on this page.
Host name sets the device host name. Each device connected to the gateway must
have a unique host name. This is important to set up correctly when using the
gateway and VPN.
Domain name determines the domain name for name resolution (optional).
Ethernet IP address determines the IP address used by the eth0 interface.
Network mask determines the network mask used by the eth0 interface.
Use Ethernet as default route should be set to "Yes" only if Ethernet is used as the
default gateway or router. Usually this parameter is set to "No", because either
GPRS or VPN is used as the default route. This parameter overrides the next
parameter Default Route IP Address, so that parameter has no effect if Use
Ethernet as default route is set to "No"
Default Router IP address determines the default router or default gateway used
when the direct route to the host or network is not known. Applies to the eth0
interface only. When GPRS or VPN is used as the default gateway, this parameter
is set to "0".
Section 5
RER601/603 Configurator
25
Advertisement
Table of Contents
