Dial-In; Ssh-Vpn - ABB RER601 Technical Manual

1MRS757105 B
5.4.3
5.4.4
RER601/603
Technical Manual
DNS servers When set to "User defined", DNS servers defined on the Ethernet
page are used. If set to "From GPRS network", the device receives the DNS server
IP addresses automatically from the GPRS network.
Led indication When set to "Data only", the GPRS LED blinks green when
transmitting data. When set to "Informative", the LED blinks also when connected
to the GPRS network without data transfer (GPRS context is active).
GPRS username determines the user name used for authentication, if APN requires
it.
GPRS password determines the password used for authentication, if APN requires it.
PPP idle timeout determines the maximum idle time for the GPRS interface. If the
GPRS interface has been idle (no traffic) for this period, the GPRS connection is
restarted.
Maximum MTU value determines the maximum transfer unit (MTU) for GPRS.
Use GPRS as default route If enabled, GPRS is used as the default route. The
Ethernet default gateway has to be disabled by setting the parameter Use Ethernet
as default route to "No" in Network/Ethernet.

Dial-in

The device's PPP dial-in interface is configured via the Dial-in command in the
Network menu. Clicking this command displays the Dial-in settings in the content
area.
Dial-in enabled If enabled, PPP connections can be made to the device (GSM data).
Require authentication (PAP) determines if password authentication is used for
incoming data calls.
Required username determines the PAP user name.
Required password determines the PAP password used for authentication.
Idle timeout determines the length of idle time before the PPP connection is
terminated.
Local IP address determines the IP address used in the PPP peer.
Peer's IP address determines the IP address used in the PPP peer.
Maximum MTU value determines the maximum transfer unit (MTU) for dial-in
connections.

SSH-VPN

The device has a VPN client that can be used with the gateway.
Section 5
RER601/603 Configurator
27