Table of Contents
Advertisement
Section 9
Appendix 1 Installation and mounting instructions
76
1.
If the SIM card has the PIN code querying enabled, configure the PIN code
before inserting the card in the card holder.
2.
Connect to the device and log in to the RER601/603 configurator.
3.
Navigate to Network/GPRS.
4.
Type the access point name in the Access Point Name (GPRS) box.
Usually, the access point name is "INTERNET"
5.
Set the GPRS network user name and password if the GPRS service requires
authentication.
6.
Set the default route to "Enabled".
7.
The parameters PIN code and PPP idle timeout (sec) are optional.
•
If the SIM card has the PIN code set, type the code in the PIN code box.
•
PPP idle timeout (sec) defines the interval in seconds when the device
resets the GPRS connection if the connection is idle.
•
ICMP Echo is used to monitor the GPRS connection between the
device and the remote host. If the host cannot be reached, the GPRS
connection is reset. This feature should always be enabled from
Network/Monitor.
8.
Click Apply. After confirmation, click Commit to save the settings.
9.
Restart the device for the settings to take effect. Check the GPRS status from
Network/Summary.
Set the correct PIN code with the RER601/603
configurator before plugging in the SIM card. If an
incorrect PIN code is set and the PIN code is required by
the SIM card, the device does not retry with the wrong
PIN code, thus avoiding a SIM card lock-up. In such a
case, insert the SIM card to a mobile phone and enter the
correct PIN code before continuing.
1MRS757105 B
RER601/603
Technical Manual
Advertisement
Table of Contents
