Extension Base Power Supply Module - Mitsubishi Electric A173UHCPU User Manual

1. SPECIFICATIONS OF MOTION SYSTEM COMPONENTS

1.5.2 Extension Base Power Supply Module

Item
Mounting position in base
Input power supply
Input frequency
Max. apparent input power
Rush current
Rated output current
1
Overcurrent protection *
2
Overvoltage protection *
Efficiency
Withstand voltage
Insulation resistance
Noise immunity
Power indicator
Terminal screw size
Applicable power cable size
Applicable solderless terminal
Applicable tightening torque
External dimensions mm (inch)
Weight kg (lb)
Permissible instantaneous power interruption time
(1) Power supply module specifications
Table 1.5 Power Supply Module Specifications
5VDC
24VDC 10%
5VDC
24VDC
5VDC
24VDC
2,830VAC rms/3 cycles across all inputs/LG and all outputs/FG (altitude 2,000m
(6557.38 ft))
5M
outputs/FG
(1) By noise simulator of 1,500Vp-p noise voltage, 1 s noise width and 25 to
60Hz noise frequency
(2) Noise voltage IEC801-4, 2kV
POINT
*1: Overcurrent protection
When current in excess of the specifications flows through the 5 VDC or
24 VDC circuits, the overcurrent protection device breaks the circuit and
stops the system.
A drop in voltage will extinguish or dim the power supply module
indicator "POWER" display.
After overcurrent protection operates, start up the system after
eliminating the cause, such as insufficient current capacity or short
circuit.
The system initial start commences when the current returns to the
normal level.
*2: Overvoltage protection
When an overvoltage of 5.5 V to 6.5 V is applied to a 5 VDC circuit, the
overvoltage protection device breaks the circuit and stops the system.
The power supply module indicator goes out.
To restart the system, switch the input power supply off, and then turn it
back on. The system initial start commences.
If the system does not start up and the indicator "POWER" display
remains off, the power supply module must be changed.
A1S61PN
Power supply module mounting slot
200 to 240 VAC
(85 to 264 VAC)
50/60 Hz
5A
5.5 A min.
or more by 500VDC insulation resistance tester across all inputs/LG and all
RAV 1.25-3.5
130 54.5 93.6 (5.12 2.15 3.69)
1 − 25
Specifications
A1S62PN
+10%
-15%
5%
105VA
20A 8ms max.
3A
0.6A
3.3 A min.
0.66 A min.
5.5 to 6.5 V
65% min.
LED indicator
M3.5 7
2
0.75 to 2mm
RAV 2-3.5
59 to 88 N⋅cm
0.6 (1.32)
20ms max.