NEC Univerge SV8100 Features And Specifications Manual page 927

UNIVERGE SV8100
Program
Program Name
Number
11-01-01 System Numbering – Service
Code
11-02-01 Extension Numbering – Dial (Up
to 8 Digits)
14-05-01 Trunk Group – Trunk Group
Number
14-18-03 IP Trunk Data Setup – P2P Mode
14-18-04 IP Trunk Data Setup – Video
Mode
15-05-43 IP Telephone Terminal Basic
Data Setup – Video Mode
20-08-13 Class of Service Options
(Outgoing Call Service) – ISDN
CLIP
21-17-01 IP Trunk (SIP) Calling Party
Number Setup for Trunk
IP Trunk – (SIP) Session Initiation Protocol
Description/Comments
Assign the 1st and 2nd dial digit to
F-Route for Remote System
Extension Numbering.
Assign extension numbers to
Extension ports.
Assign SIP Trunks to same Trunk
Group.
Enable/Disable P2P Mode.
For Video Call via the System

Interconnection set to 1
(Enable).
Enable/Disable Video Mode.
For Video Call via the System

Interconnection set to 1
(Enable).
Enable/Disable Video Mode for
Standard SIP terminals.
For Video Call via the System

Interconnection set to 1
(Enable).
Determine if the ISDN calling line
identity presentation and
screening indicators should be
allowed.
Assign the Caller Party Number for
each IP trunk. The assigned
number is sent to the central
office when the caller places an
outgoing call. If the Calling Party
Number is assigned by both
Program 21-17 and Program
21-18/ 21-19, the system uses the
entry in Program 21-18/21-19.
Assigned Data
1
Refer to System
Numbering Default
Settings table in the

UNIVERGE SV8100
Programming Manual
for a list of default
settings.
Up to eight digits
1 101
2 102
3 103
~ ~
99 199
100 3101
~ ~
512 3513
Trunks 1~200
Trunk Port 1~200,

Group 1,
Priority 1~200
0 = Disable
1 = Enable

(default = 0)
0 = Disable
1 = Enable

(default = 0)
0 = Disable
1 = Enable

(default = 0)
0 = Off
1 = On
(default = 0)
Up to 16 Digits
#
(1~0, , )

(default not assigned)
Issue 13.0
Level
2 3



2 - 893