Spe(M)-U( ) Etu Configuration; Configuring Spe(M)-U( ) Etu; Table 3-1 Factory Network Settings - NEC Electra Elite IPK Installation And Maintenance Manual

C h a p t e r 3
___________________________________________________________________________________
S 1
ECTION
C
Set the DIP switch SW 4-8 to the desired settings on the SPE(M)-U ( ). Refer to
Switch Settings on page
Place the SPE(M)-U( ) ETU Ethernet port in the Electra Elite IPK KSU in the
appropriate slot of the KSU. Refer to
that the SPE card can be installed in.
Connect the Ethernet cable to the Ethernet connector on the SPE(M)-U( ) ETU. This
is the bottom most connector on the SPE(M)-U( ) ETU. Refer to
on page
factory-set default parameters as shown in
In this configuration, the Ethernet port cannot be used in any randomly given
environment, and its parameters must be redefined before the SPE(M)-U( ) ETU can
work in your environment. The required parameters can be set by using the web
browser and connecting to the default IP Address (192.168.1.100) in the browser
navigation address bar. Refer to
page A-1
___________________________________________________________________________________
SPE Hardware, Installation, and Maintenance Manual

SPE(M)-U( ) ETU Configuration

O N F I G U R I N G
S P E ( M ) - U ( ) E T U
1-3. When installed for the first time, the SPE(M)-U( ) ETU, comes up with
IP Address
Subnet Mask
Default Gateway
for a detailed description of this configuration utility.
1-5.
On = MIFM Mode Only
Off = SPE Mode (Default)
2.3 Installation on page 1-5
Table 3-1 Factory Network

Table 3-1 Factory Network Settings

192.168.1.100
255.255.255.0
192.168.1.1
Appendix A Web-Based Setup and Configuration on
2.4
for appropriate slots
Section 2 Hardware
Settings.
3 - 1