Electra Elite IPK
___________________________________________________________________________________
Proceed to Downloading/Uploading the system data as if you were directly connected
to the system via Serial or Modem connection.
S
3
R
ECTION
ETURNING THE
This section allows an SPE(M)-U( ) ETU to return to factory default settings.
Step 1. Remove the SPE(M)-U( ) ETU from the system.
Step 2. Set DIP switch SW 4-2 to the following:
Step 3. Reinsert the SPE(M)-U( ) ETU into the system. Once the LEDs have lit
___________________________________________________________________________________
SPE Hardware, Installation, and Maintenance Manual
Figure C-8 Screen Showing SAT is Connected
SPE(M)-U( ) ETU
SW4 – 2 to (ON = Restores card to factory defaults)
according to the boot procedure, remove the SPE ETU from the system.
F
D
TO
ACTORY
EFAULT
Document Revision 1
C
ONFIGURATION
C - 9