NEC Electra Elite IPK Installation And Maintenance Manual page 42

Electra Elite IPK
___________________________________________________________________________________
C o n n e c t i o n S t a t u s .
Mapping Caveats
There is some complexity within the Virtual Serial Port Mapping section because
there are multiple instances of COM 4. The current mapping restrictions are as
follows:
___________________________________________________________________________________
SPE Hardware, Installation, and Maintenance Manual
The TCP port number defaults to 52992, but can be modified if needed. The
Find button allows one to verify whether or not the SPE(M)-U( ) ETU is
reachable and working. The Modem Method allows the user to enter the
telephone number of the SPE modem and to enter dialing properties, such as
area codes, outside line dialing, etc.
Once the Connection Method selection has been made and
the Connect command has been issued, the Connection Status field will
reflect the actual status of the SPE(M)-U( ) ETU connection. The following are
the possible status conditions and their meaning.
Disconnected indicates that no connection to the SPE(M)-U( ) ETU is present.
Attempting Connection indicates that the SPE Application is attempting to
connect to the SPE(M)-U( ) ETU via the connection method chosen. The
indicator will display the Connection Method being attempted such as
"Serial:Attempting Connection".
Connected:Serial indicates that the SPE Application is connected via the direct
Serial or COM port on the PC.
Connected:Ethernet indicates that the SPE Application is connected to the
SPE(M)-U( ) ETU via an Ethernet port at the IP address indicated in the
Connection Method box.
Modem:Connected at (indicated speed) indicates that the SPE Application is
connected to the SPE(M)-U( ) ETU via the modem. It also indicates the speed at
which it connected (i.e. "Modem:Connected at 33600")
Modem:Call is Proceeding indicates that the PC modem is attempting to dial
into the SPE modem.
Please wait...disconnecting... indicates that the SPE Application is in the
process of disconnecting either due to a disconnect command or an error
condition.
Ethernet:Busy: Ethernet indicates that the SPE App is currently connected via
another SPE Application. The first "Ethernet" before the word "Busy" is the
connection being attempted by the user. The "Ethernet" after the word "Busy" is
what is actually connected and busy. The SPE Application will not allow a
connection if it detects another SPE Application or PC Application is connected.
The same holds true for a Serial connection (i.e. "Ethernet:Busy:Serial" or
"Serial:Busy:Ethernet").
WSC (COM4) and Cosession (COM4) cannot be selected at the same time.
Document Revision 1
B - 5