Panasonic KX-TDA0480 Installation Manual page 29

Unit Identification Information
Use the unit identification information line to record information used to identify a Group to
which a unit belongs, and to identify the individual unit.
Group Name
Use the Group Name field to assign a group in which to create and store the KX-TDA0480 in
the Maintenance Console Software.
Each KX-TDA0480 must be assigned to a Group. The New Group command is used to enter
this information in the Maintenance Console Software. This must be done before units
(Gateways) can be created.
The Unit Name field allows for entry of an unrestricted alphanumeric string.
In the sample worksheet, the Group Name is New York.
Unit Name
Use the Unit Name to enter a name to be associated with a unit (Gateway) in the Maintenance
Console Software. The Maintenance Console Software requires this information before a unit
can be defined and configured using the Maintenance Console Software.
The Unit Name field allows entry of an unrestricted alphanumeric string.
In the sample worksheet, the Unit Name is NY01.
General
Use the General section of the worksheet to record unit IP addressing and password access
information.
See Appendix A1 Voice Over IP Addressing.
Unit IP (VHUB_IP)
Use this field to record a unit's unique IP address.
This address must conform to Internet Protocol addressing requirements, e.g.
nnn.nnn.nnn.nnn, where nnn = a value of 0 to 255 excluding 0.0.0.0 and 255.255.255.255. The
default setting is 192.168.1.200.
IP addressing information is typically supplied by a network administrator.
In the sample worksheet the Unit IP is recorded as the default address, 133.149.1.91.
Installation Manual
Planning
29