Panasonic KX-TDA0480 Installation Manual page 65

Unit Setup Wizard 2 of 6
Use the Setup Wizard screen 2 to enter the unit's IP addressing information. The IP Address,
Subnet Mask, and Gateway 1 IP address fields are required.
Be careful to insure that all IP addressing information is correctly entered. Errors in entering
this data can produce problems that are difficult to diagnose later in the installation process.
1.
Select the IP Address field and enter the IP Address for the unit.
2.
Select the Subnet Mask field and enter the Subnet Mask IP address.
3.
Select the Route IP Address 1 field and enter the address of the primary Gateway to which
the unit is connected. This is usually the IP address of a router or similar network device.
4.
If a secondary (e.g., backup) Gateway device is used in association with the unit, enter the
Route IP Address 2.
5.
Click on the Next button when finished entering information or click on the Cancel button
to exit the Wizard and lose all changes.
If an IP address that is not allowed is entered, the MCS will issue an error message so that the
value can be corrected.
Installation Manual
Logical Installation
65