Maintenance Schedule - Beta Marine Beta 10 Operator's Maintenance Manual

Section 3

Maintenance Schedule

Daily or every 8 hours running
• Check engine oil level.
• Check gearbox oil level.
• Check coolant level.
• Check battery fluid.
• Check drive belt tension
• Ensure raw water inlet strainer is clear.
• Check stern gland lubrication (if used).
• Drain off any water in fuel/water separator.
After the first 25 hours running
• Change gearbox lubricant (See separate gearbox manual).
• Check that all external nuts, bolts and fastenings are tight.
See table for torque values. Do NOT over tighten. Special
attention should be paid to the flexible mount lock nuts,
these should be checked for tightness, starting with lower
nut first in each case. If the lower nuts are found to be
very loose, then the alignment of the shaft to the gearbox
half coupling should be re-checked. Poor alignment due
to loose flexible mount nuts will cause excessive vibration
and knocking.
• Check the belt tension on any second alternators fitted
and adjust, see page 11.
• Check ball joint nyloc nuts for tightness on both gearbox
and speed control levers. Grease both fittings all over.
After first 50 hours
• Change engine lubricating oil.
• Change oil filter.
• Check for leaks on header tank tubestack. Tighten end
cap bolt if required.
• Drain off any water in fuel/water separator.
Every 150 hours
• If shallow sump (option) is fitted, change engine
lubricating oil and filter.
Every year or 250 hours if sooner
• Change engine lubricating oil (standard sump)
• Change lubricating oil filter
• Check air cleaner element
• Check sea water pump impeller and change if worn.
• Check wasting anode condition, replace when necessary.
In some environments this may be six monthly or less.
• Remove heat exchanger tube stack, by undoing the bolt
each end of the tube stack. Remove end cover, pull out
tube stack and clean. Replace rubber 'O' rings and re-
assemble. Top up with antifreeze. Immediately engine is
started check for leaks.
• Spray the key switch with WD40 or equivalent to
lubricate the barrel.
• Check that all external nuts, bolts and fastenings are tight.
See table for torque values.
• Check ball joint nyloc nuts for tightness on both gearbox
and speed control levers.
Every 750 hours (In addition to 250 hours maintenance)
• Change air cleaner element.
• Change fuel filter.
• Change antifreeze.
• Change gearbox oil.
• Check electrical equipment, condition of hoses and belts,
replace as necessary.
17